Chapter 5: IP interface translations
To administer IPSI circuit packs, use a terminal emulation program to issue Communication Manager SAT commands.
For Communication Manager terminal emulation, use a program such as Avaya Native Configuration Manager, Avaya Terminal Emulation, or HyperTerminal.
You also can use Avaya Site Administration to issue SAT commands. To administer some of the features in the latest release of Avaya Communication Manager, you must use the latest version of Avaya Site Administration.
Perform these tasks to administer IPSI circuit packs:
●Inputting initial system translations on page 49
●Adding media gateways on page 50
●Enabling the IPSI on page 51
●Adding the IPSI to the system on page 52
●Setting the alarm activation level on page 52
●Saving translations on page 52
Inputting initial system translations
1.Open a SAT session. See Using the SAT command line prompt on page 93.
2.Enter translations:
If the system translations were prepared offsite, enter the translations and reset the media server.
If the translations are not available, enter minimal translations to verify connectivity to the port networks.
3.After you enter the translations, type save translation and press Enter to save the translations to the hard disk drive.
4.Type reset system 4 and press Enter to have the software read the copied translations.
Installing and Configuring the Avaya S8500 Media Server | February 2007 49 |
