Universal Power Supply | Barco RCP-120 specs

B. Universal Power Supply

Overview

The RCP120 device is powered with a Universal Swit chMode power supply, prefit with the 2pin Phoenix connector needed to connect to the RC P120. The figure below illustrates the power supply and the included universal power blade adapters:

Installing a Power Blade Adapter

1.To remove an existing power blade adapter or the protective insert installed on a new supply, grasp the supply firmly in one hand and use your thumb or forefinger to pull down the release tab as indicated with the red arrow in the illustration below:

48	Remote Control Panel User’s Guide ● Rev 00

Image 48

Barco RCP-120 manual Universal Power Supply, Installing a Power Blade Adapter

Contents

RCP120 Remote Control Panel User’s Guide Remote Control Panel User’s Guide Rev Copyright Company Address Trademarks Power Source Use the Proper Power CordDo Not Remove Covers or Panels Grounding the Product Terms In This Manual and Equipment Marking Rev Date Description Approved By 09/11 586290 Initial Release Table of Contents Universal Power Supply This page intentionally left blank Introduction Overview Connectivity Diagram Application Questions Remote Control Panel Orientation RCP120 Front PanelRCP120 Rear Panel 2in Phoenix DC Power Input 4in Phoenix RS32 / IRLAN Installation Unpacking and InspectionWhat’s Included in the Box RCP120 Installation RCP120 Configuration Soft Reboot / Web Interface Password ResetConnecting to the RCP120 Web Interface Remote Control Panel User’s Guide Rev RCP120 Configuration RCP120 Configuration Web Interface Network ConfigurationStatus Change Admin Password Master Controller IP Address Serial Port 1 Configuration / Baud Rate Serial Port 2 Configuration / Baud RateSerial Port 1 Auto Transmit Button Settings Update and Reboot / Reset DefaultsSeconds Before Default Setting is 0 No Timeout. Used to Delay Between Default Setting is 30 0.3 Seconds. Used to RCP120 Boot Menu Connecting to the Boot MenuOverview RCP120 Boot Menu Interface Restore Default Settings Discard Changes and RebootSave Changes and Reboot Selections Not Supported RCP120 FSN Menu Orientation Assign Remote Panels Remote Control Panel Table Figure below illustrates the Remote Control Panel Table Discover Remote Panels Assign Aux Unassign Assign Remote Panels Menu Functions Info Duplicate IP Address Notification Operations No Connection BehaviorDisplay IP/MAC Address and Firmware Version AUX Output Control Understanding Button Mapping Understanding Button Color Button Color Table Working with the RCP120 Remote Control Panel User’s Guide Rev Setting up the RCP120 to Control an Aux Output FSN System and Controller SetupRCP20 Setup Maintenance Operations Adding Additional RCP20 DevicesUnassign an Aux Output from an RCP20 Working with an Unconnected RCP20 Controlling an Aux Output with the RCP120 Controlling a Standard Aux Output Controlling an Aux Output defined as a Mixer Program Preview Software Update Overview Updating SoftwareHardware Requirements Downloading Software Via FTP SiteRCP20revision #.zip Via Web Site Updating RCP120 Software RCP20 Firmware Upload Remote Control Panel User’s Guide Rev Specifications Physical and Electrical Specifications Communications Specifications Agency SpecificationsPower Connector Connector Specifications Figure below illustrates the 4pin Phoenix powe r connector Serial Port Universal Power Supply Installing a Power Blade Adapter Remote Control Panel User’s Guide Rev Warranty Return Material Authorization RMAContact Information Contact Information Barco, IncSales Contact Information Barco N.V