Button Settings
This section allows a user to change the behavior of the buttons on the RCP120.
Figure 36: Button Settings
Seconds Before Default Setting is: 0 (No Timeout). Used to
Display Timeout: change the number of seconds before the Display Backlight turns off. When used with the FSN Controller, this value should remain at 0 as backlight color is used to convey current status.
Delay Between Default Setting is: 30 (0.3 Seconds). Used to
Repeated Presses: change the number of seconds between repeated button presses when the button is held down. When used with the FSN Controller, leave this set to the default value.
Update and Reboot / Reset Defaults
After making changes to any of the settings in the Web Configuration page, click on the “Update and Reboot” button to save your settings and to have the new settings take effect.
To go back to Factory Defaults, click the “Reset to Defaults and Reboot” button. All settings in the Web Configuration page will be reset to factory default settings.
Figure 37:
Note
Update & Reboot / Factory Defaults
After a Factory Reset, the Admin Password for the web interface will be reset back to “admin”.
22 | Remote Control Panel User’s Guide ● Rev 00 |
