Remote Control Panel User’s Guide ● Rev 00 19
RCP-120 Configuration Web Interface Status
This section of the configuration web page shows the current status. Information includes
the unit’s Serial Number and MAC Address. The current Network Configuration settings are
shown next followed by the Current Script and Firmware Version.
Figure 3-2: Configuration Status section
Network Configuration
This section allows a user to change the current DHCP Setting, IP Address, Subnet Mask,
Gateway, Hostname and Master Controller IP Address.
Figure 3-3: Network Configuration
DHCP: Default setting is: OFF. When using the RCP-120 with an FSN
System, leave DHCP set to OFF.
Static IP Address: Default IP Address is: 192.168.0.100. This is the IP
Address of the RCP-120. Make sure each RCP-120 on
the network has a unique IP Address. Failure to do so
will cause unexpected communication behavior.