Belkin PM11-UL/RAMA, PM11-EL/RAMA, PM11-EC/RAMA Hardware Installation Wake-On-LAN Connector, +5VSB

Hardware Installation

2.6.18 Wake-On-LAN Connector

	3 2 1 Wake-On-LAN
	(J7)
Pin	Function
1	WOL
2	Ground
3	+5VSB

The mainboard supports the Wake-On-LAN function. This function will allow the network to remotely power-on a Soft Power Down (Soft-Off) PC. However, if your system is in the Suspend mode, you can power-on the system only through an IRQ or DMA interrupt.

To use the Wake-On-LAN function, you must enable “Resume on LAN/Ring” in the Power Management Setup (“IRQ/Event Activity Detect” field) of the BIOS. Your LAN card package should include a cable. Connect one end of the cable to the wakeup header on the card and the other end to location J7 on the mainboard. The network will detect Magic Packet and assert a wakeup signal to power-up the system. Refer to the add-in card’s manual for details. Note:Your LAN card must support the remote wake up function.

Important:

The 5VSB power source of your power supply must support

≥720mA.

2

49