Belkin PM11-EC/RAMA, PM11-EL/RAMA, PM11-UL/RAMA Hardware Installation Wake-On-Ring Connector, Ri#

2

Hardware Installation

2.6.19 Wake-On-Ring Connector

	2	1
		Wake-On-Ring
		(J16)
Pin	Function
1	Ground
2	RI#

The Wake-On-Ring connector is used to connect to an internal modem card that has the same connector. It will allow the system that is in the Suspend mode or Soft Power Off mode to wake-up/ power-on to respond to calls coming through the internal modem card.

To use this function, connect one end of the cable (that came with the card) to the card’s wake-on-ring connector and the other end to location J16 on the mainboard. You must also enable “Resume on LAN/Ring” in the Power Management Setup (“IRQ/Event Activity Detect” field) of the BIOS.

If you are using an external modem, the ring-on function will come through the serial port where the external modem is connected.

Important:

If you are using a modem add-in card, the 5VSB power source of your power supply must support ≥ 720mA.

50