Blaupunkt 7 645 650 310 operating instructions Video Setup image settings, Setting the Lpcm

DVD OPERATION

Setting the LPCM

This device can be used to output a linear PCM signal (LPCM) with a sam- pling rate of 48 K, 96 K or 192 K.

The LPCM setting is located under ÒLPCM OUTÓ in the ÒSPDIF SetupÓ.

Dolby Digital Setup - Dynamic Range Control

Dynamic Range Control means that the difference between ÒloudÓ and ÒsoftÓ sounds is adjusted. The volume of soft sounds is increased and that of loud sounds is lowered. You can use the DRC of the device to set the dynamics of a Dolby programme in increments from ÒOFFÓ to ÒFullÓ. Select the ÒFULLÓ setting for full dynamic adjustment.

The setting of DRC is located under ÒDynamicÓ in the ÒDolby Digital SetupÓ.

Setting the HDCD filter

If you play HDCD-DVDs or CDs (High Definition Compatible Digital), you can select a filter.

Select the desired filter under ÒHDCDÓ.

Brightness

You can adjust the brightness in incre- ments from -20 to +20.

The setting for brightness is located in ÒQualityÓ under ÒBrightnessÓ.

Contrast

You can adjust the contrast in incre- ments from -16 to +16.

The setting for contrast is located in ÒQualityÓ under ÒContrastÓ.

Gamma correction

You can adjust the gamma correction for playback on TFT displays. You can select among the settings ÒHighÓ, ÒMe- diumÓ, ÒLowÓ, and ÒNoneÓ.

The setting for gamma correction is located in ÒQualityÓ under ÒGammaÓ.

Colour

You can adjust the colour in increments from -9 to +9.

The setting for colour is located in ÒQualityÓ under ÒHueÓ.

Colour saturation (for NTSC only)

DEUTSCH ENGLISH FRAN‚AIS ITALIANO NEDERLANDS SVENSKA

Video Setup - image settings

In the Video Setup, you can perform different settings for an optimal image playback on the connected display.

Adjusting picture sharpness

To adjust the picture sharpness, you can select among the settings ÒHighÓ, ÒMediumÓ and ÒLowÓ.

The setting for picture sharpness is lo- cated in ÒQualityÓ under ÒSharpnessÓ.

You can adjust the colour saturation in increments from -9 to +9.

The setting for colour saturation is lo- cated in ÒQualityÓ under ÒSaturationÓ.

Luminance (for NTSC only)

You can select the settings Ò0TÓ and Ò1TÓ for luminance.

The setting for luminance is located in ÒQualityÓ under ÒLuma DelayÓ.

ESPA„OL PORTUGUæS DANSK

99