Bosch Appliances installation manual En Installing the Dinion capture Dinion capture 5000 IP

22 en Installing the DINION capture DINION capture 5000 IP

should be anchored in concrete or welded to a steel backer plate.

Refer to the MBE Mounts and Adapters Installation Guide for more details about attaching the bracket to an MBE-15 Pole Mount Adapter or to the MBE-17 Wall Mount Adapter.

1.Use the wall mount template supplied in the packaging box to locate the four mounting holes for the camera bracket.

2.Drill four (4) holes for the mounting bolts. If installing outdoors, apply a weatherproof sealant around each hole at the mounting surface.

3.Route the cable. If routing the cable through the wall, drill a 25.4 mm (1 in.) hole following the wall mount template and use a weatherproof sealant to seal around the cable to ensure a weather tight seal between indoors and outdoors, otherwise route the cable through one of the side holes in the mounting bracket by removing the plug and routing the cable through.

WARNING!

A stud/bolt diameter of 6.0 mm (or 1/4 inch) able to withstand a 300 kg (660 lb) pull-out force is recommended. The mounting material must be able to withstand this pull out force.

4.Secure the mounting bracket to the mounting surface. Use four (4) corrosion-resistant, stainless steel studs or bolts, nuts, washers, and lock washers (not supplied).

5.Adjust the license plate camera angle using the range and angle recommendations in Section 3.1 Determining the Range, page 19.

–Connect the imager to a local monitor to assist adjusting the license plate camera. For DINION capture 5000 IP cameras, refer to Section 3.4.3 Video Connection for Installation, page 25.

1.0 2012.01 Installation Manual Bosch Security Systems, Inc.