DINION capture 5000 IP Safety | en 9
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01
8. Power disconnect - Units have power supplied to the unit
whenever the power cord is inserted into the power
source. The power cord plug is the main power disconnect
device for switching off the voltage for all units.
9. Power sources - Operate the unit only from the type of
power source indicated on the label. Before proceeding,
be sure to disconnect the power from the cable to be
installed into the unit.
– For external power supplied units, use only the
recommended or approved power supplies.
– For limited power source units, this power source
must comply with EN60950. Substitutions may
damage the unit or cause fire or shock.
– For 24 VAC units, voltage applied to the unit's power
input should not exceed ±10%, or 26.4 VAC. User-
supplied wiring must comply with local electrical
codes (Class 2 power levels). Do not ground the
supply at the terminals or at the unit's power supply
terminals.
– If unsure of the type of power supply to use, contact
your dealer or local power company.
10. Servicing - Do not attempt to service this unit yourself.
11. Damage requiring service - Unplug the unit from the main
AC power source and refer servicing to qualified service
personnel when any damage to the equipment has
occurred, such as:
– the power supply cord or plug is damaged;
– internal exposure to moisture, water, and/or
inclement weather (rain, snow, etc.);
– liquid has been spilled in the equipment;
– an object has fallen into the unit;
– unit has been dropped;
– unit exhibits a distinct change in performance;
– unit does not operate normally when the user
correctly follows the operating instructions.