DINION capture 5000 IP Safety | en 13
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01
Environmental statement - Bosch has a strong commitment
towards the environment. This unit has been designed to
respect the environment as much as possible.
Electrostatic-sensitive device - Use proper CMOS/MOS-FET
handling precautions to avoid electrostatic discharge.
NOTE: Wear required grounded wrist straps and observe proper
ESD safety precautions when handling the electrostatic-
sensitive printed circuit boards.
Fuse rating - For protection of the device, the branch circuit
protection must be secured with a maximum fuse rating of 16A.
This must be in accordance with NEC800 (CEC Section 60).
Moving - Disconnect the power before moving the unit. Move
the unit with care. Excessive force or shock may damage the
unit.
Outdoor signals - The installation for outdoor signals, especially
regarding clearance from power and lightning conductors and
transient protection, must be in accordance with NEC725 and
NEC800 (CEC Rule 16-224 and CEC Section 60).
Permanently connected equipment - Incorporate a readily
accessible disconnect device external to the equipment.
Pluggable equipment - Install the socket outlet near the
equipment so it is easily accessible.
PoE Plus - Use only approved PoE Plus devices.
By default, power is supplied to the camera via the standard
(11-30 VDC or 24 VAC) power connection. If connection is
made via the Ethernet cable, compliant with the Power-over-
Ethernet (IEEE 802.3at Type 2) standard at the same time as
the standard connection, the standard connection will prevail
without damage to the device. To use PoE Plus, standard power
must be turned off.