DINION capture 5000 IP | Installing the DINION capture en 31 |
|
|
Mode Details
Mode 2 (FullSun) is two (2) gain points less than the normal mode, by default. You can modify both mode settings as needed in order to provide the desired image throughout the day.
When modifying settings, first verify which mode is active by clicking the Settings link at the top of the page. Then click on Advanced Mode and navigate to Camera>PictureSettings>Mode. The active model shows in the Current Modedrop down box.
If changes are made to Mode 1 (Normal) ensure that the offset change is made to Mode 2 (FullSun). For example, if the plate image is too bright in Mode 1 (Normal) and you change the gain from 8 to 6, then you should change the gain in Mode 2 (FullSun) from 6 to 4.
Important:
After changes are made to any settings ensure the DINION capture is left in mode 1 under Camera>Picture Settings (refer to Section 8.4.1 Mode, page 64).
To setup Automatic Mode Switching:
1.Ensure to setup during the brightest conditions of the day, the plate image should appear very bright before setup.
2.Remove the back panel of the housing and locate the potentiometer on the right.
Bosch Security Systems, Inc. | Installation Manual | 1.0 2012.01 |
