30 en Installing the DINION capture | DINION capture 5000 IP |
|
|
1.Remove the back panel. Refer to Section 3.6 Connecting to a Coax Cable, page 27 for instructions.
2.Locate the reset button, towards the center of the imager.
3.With the power on, press and hold the reset button for more than ten (10) seconds to restore the factory defaults.
4.Replace the rear panel.
3.9Automatic Mode Switching
Automatic Mode Switching is a feature on the license plate camera that automatically compensates for bright conditions. Automatic Mode Switching, by default, operates by switching from Mode 1 (Normal) to Mode 2 (FullSun) when the ambient light levels rise above normal conditions (for example, bright sunlight on the scene). Automatic Mode Switching is inactive by default and requires setup to operate as desired.
In most conditions, Automatic Mode Switching may not be necessary. Activate the switch only if the license plate camera operates as desired during darker conditions but overexposes the image during sunny conditions.
IMPORTANT: Only setup Automatic Mode Switching if the target license plate is in the sun and the captured image is overexposed, never setup if the license plate is in the shade.
1.0 2012.01 | Installation Manual | Bosch Security Systems, Inc. |
