44 en | Operation via the browser DINION capture 5000 IP
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
6.1.3 Digital I/ODepending on the configuration of the unit, the alarm input and
the relay output are displayed next to the camera image. The
alarm symbol is for information and indicates the input status
of the alarm input: Active 1 = Symbol lights, Active 0 = Symbol
not lit. The relay on the camera allows the operation of a device
(for example, a light or a door opener).
– To operate, click the relay symbol. The symbol is red when
the relay is activated.
6.1.4 System Log / Event LogThe System Log field contains information about the operating
status of the camera and the connection. These messages can
be saved automatically in a file. Events such as the triggering or
end of alarms are shown in the Event Log field. These messages
can be saved automatically in a file. To delete the entries, click
the icon in the top right-hand corner of the relevant field.
Motion flag set on media item
Discovery of storage not completed.
If the information about recorded video is not
cached, a discovery procedure is started to find
all recorded video. During this time, the discovery
symbol is shown. While discovery is executed,
gaps might be shown in places which the
discovery has not yet reached. The gap will be
automatically replaced by the true video, as soon
as the correct information is available.
NOTICE!
Alarm 1 is reserved for Automatic Mode Switching, when Mode
2 (FullSun) is active the symbol will be lit. Automatic Mode
Switching must be activated to operate, refer to
Section 3.9 Automatic Mode Switching, page 30.