Bosch Appliances 5000 IP installation manual Making the Connections

26 en Installing the DINION capture DINION capture 5000 IP

3.5Making the Connections

WARNING!

Before proceeding, disconnect the power from the power supply cable. Ensure that the voltage of the unit matches the voltage and type of the power supply being used.

The easiest way to connect the cables is as follows:

1.Bring the building connections through the surface cable hole so that they hang clear.

2.Connect the Ethernet cable with connector to RJ-45 jack coming from the DINION capture 5000 IP.

3.Connect the ferrule tipped power wires (red, black; polarity independent) to the power supply connection if power is not supplied via PoE+ over the Ethernet cable. Note: You can connect the imager to a PoE+ and to an 11- 30 VDC / 24 VAC supply simultaneously.

4.In damp environments ensure that the connections are sealed inside a junction box or a field wiring box with NEMA 3 or IP55 protection level or better. Make the connections inside the water tight compartment. After connections are made ensure that the watertight compartment is tightly closed and cables and conduits are properly sealed to prevent ingress of water.

1.0 2012.01 Installation Manual Bosch Security Systems, Inc.