14 en Safety

DINION capture 5000 IP

 

 

Power lines: An outdoor system should not be located in the vicinity of overhead power lines, electrical lights, or power circuits, or where it may contact such power lines or circuits. When installing an outdoor system, extreme care should be taken to keep from touching power lines or circuits, as this contact may be fatal.

U.S.A. models only - refer to the National Electrical Code Article 820 regarding installation of CATV systems.

11-30 VDC / 24 VAC power source: This device is intended to operate with a limited power source; this power source must comply with EN60950. The device is designed to operate at either 11-30 VDC or 24 VAC (if PoE is not available). User supplied wiring must be in compliance with electrical codes (Class 2 power levels). If 24 VAC is used, do not ground the

24 VAC supply at the terminals or at the device's power supply terminals.

Connections: The unit has connection terminals on flying leads. In wet or outdoor installations use a field wiring box with NEMA 3 or IP55 protection level or better. Make the connections inside the water tight compartment. After connections are made ensure that the watertight compartment is tightly closed and cables and conduits are properly sealed to prevent ingress of water.

SELV - All the input/output ports are Safety Extra Low Voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits.

Because ISDN circuits are treated like telephone-network voltage, avoid connecting the SELV circuit to the Telephone Network Voltage (TNV) circuits.

1.0 2012.01

Installation Manual

Bosch Security Systems, Inc.

Page 14
Image 14
Bosch Appliances installation manual En Safety Dinion capture 5000 IP