Bosch Appliances 5000 IP 8.7 Interfaces

DINION capture 5000 IP Advanced Mode | en 103

Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01

8.7 Interfaces

Configure the alarm triggers for the camera.

Select N.C. (Normally Closed) if the alarm is to be triggered by

closing the contact.

Select N.O. (Normally Open) if the alarm is to be triggered by

opening the contact.

Select None to disable the input.

Note: Input 1 is reserved for Automatic Mode Switching.

Name

Enter a name for the alarm input. This name can be displayed

below the icon for the alarm input on the LIVEPAGE. (Do not

use any special characters, for example &.)

Action

Select the camera mode to switch to when alarm input 1 is

triggered.

Note:

See Section 8.6.8 Alarm Task Editor, page 102, for information

on alarm actions based on alarm inputs.

Configure the switching behavior of the relay output.

Select different events that automatically activate an output.

For example, turn on a floodlight by triggering a motion alarm

and then turn the light off again when the alarm has stopped.

Idle state

Select Open for the relay to operate as an N.O. contact, or

select Closed if the relay is to operate as an N.C. contact.

Select

Select External device or Motion+/IVA to trigger the relay.

Relay name

The relay can be assigned a name here. The name is shown on

the button next to Trigger relay. The LIVEPAGE can also be