DINION capture 5000 IP

Safety en 11

 

 

1.3Important notices

Accessories - Do not place this unit on an unstable stand, tripod, bracket, or mount. The unit may fall and cause serious injury and/or serious damage to the unit. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer. When a cart is used, use caution and care when moving the cart/apparatus combination to avoid injury from tip-over. Quick stops, excessive force, or uneven surfaces may cause the cart/unit combination to overturn. Mount the unit per the manufacturer's instructions.

All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at least 3 mm in each pole, into the electrical installation of the building. If it is needed to open the housing for servicing and/or other activities, use this all-pole switch as the main disconnect device for switching off the voltage to the unit.

Camera signal - Protect the cable with a primary protector if the camera signal is beyond 140 feet, in accordance with NEC800 (CEC Section 60).

NOTICE!

RISK GROUP 1

IR emitted from this product.

This product has been tested according to standard CIE/IEC 62471:2006 “Photobiological safety of lamps and lamp systems” and found to meet Risk Group 1 for exposure limit

4.3.7“Infrared radiation hazard exposure limits for the eye.” For other hazard exposure limits, the product was found to be exempt. Risk Group 1 is characterized in the standard as “products are safe for most use applications, except for very prolonged exposures where direct ocular exposures may be expected.” Risk Group 1 sources do not pose an infrared radiation hazard for the eye for times less than 100 s at distances beyond 200 mm or 8 inches.

Bosch Security Systems, Inc.

Installation Manual

1.0 2012.01

Page 11
Image 11
Bosch Appliances 5000 IP installation manual Important notices, Risk Group