Bosch Appliances D6600 Installing Terminator Cards, Callout ᅳ Description, Installing Line Cards

Conettix Communications Receiver/	D6600 Specific Cards en 21
Gateway

Installing Terminator Cards

Refer to D6640/D6641 Line Cards and D6645 Line Terminator Cards, page 19 when performing the following steps:

1.Remove the two bracket screws that secure the terminator card (or card slot cover, if this is a new terminator card installation) to the back of the D6600 chassis.

2.If you are removing an existing terminator card, open the display door on the front of the D6600 and pull the line card slightly out, then re-insert. This will push the existing terminator card out the back of the D6600 chassis.

3.Remove the existing terminator card. Insert the new terminator card in the same slot by aligning the top and bottom of the terminator card with the card guides in the D6600 chassis.

4.Slide the card into the D6600 chassis, wiggling the card as you push until the card is flush with the back of the chassis.

5.Secure the bracket screws at the top and bottom of the terminator card. Ensure that the screws are tight.

6.Repeat this process for all additional terminator cards.

7.Connect appropriate telephone line cords to the telephone line jack on the terminator cards.

8.Continue to Installing Line Cards, page 21.

i	Notice!
	Even if you are replacing an existing terminator card, you must proceed to Installing Line
	Cards.

Figure 6.3: Removing and Installing the Terminator Card

Callout ᅳ Description

1 ᅳ Terminator Card (D6645 shown)

2 ᅳ Bracket screws (top and bottom)

3 ᅳ Empty slot

4 ᅳ D6600 chassis

Installing Line Cards

1.Install the terminator card(s) (Refer to Installing Terminator Cards, page 21).

Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 08 4998122704