Bosch Appliances D6600 Central Station Automation System, Callout ᅳ Description

Conettix Communications Receiver/	Central Station Automation System en 73
Gateway

14 Central Station Automation System

If using a Bosch Security Systems, Inc. receiver, connect a central station automation system computer to the COM3 port (automation computer port) on the rear of the receiver with a null-modem cable. Refer to the D6600/D6100IPv6 Computer Interface Manual (P/N: 4998122703) for additional information.

Standard automation reporting usually sends RS-232 serial data from the receiver COM3 port to a COM port of a separate automation PC (refer to COM3 Automation Configuration in the D6600/D6100IPv6 Program Entry Guide (P/N: 4998122702). With no additional programming required at the network device servers such as the D6680s/D6682, you can use the same serial communication across a network connection by using D6680s at both ends of the automation communication path. The D6600 still sends the standard serial data, but the network device servers create a "serial tunnel" and communicate with each other, convert data back to the standard RS-232 that the automation computer can interpret, and transmit data over the network.

	Notice!
i	Some messages might remain unacknowledged (NACK) because of increased network activi-
	ties. This forces the D6600 to send these messages again. Refer to Network Communications,
	page 42 for complete details on network communications and programming.
	1	2	3

5

4

Figure 14.1: Receiver system – Direct Connect

Callout ᅳ Description

1 ᅳ Host PC

2 ᅳ Connection – host PC COM port to D6100IPv6 COM3 port

3 ᅳ D6600IPv6

Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 08 4998122704