38 en D6600/D6100IPv6 Operation | Conettix Communications Receiver/ | |
Gateway | ||
| ||
|
|
Clear Pending Events (Function 4)
Use this option to clear all pending events.
Running the Clear Pending Events function:
1.Press the Function key. Enter your password and press the Enter key to go to the Welcome Manager.
2.Press [4] and Enter.
3.Press [0] to cancel the function and not delete all pending events, or press [1] to clear all pending events.
LCD/LED Availability Test (Function 5)
Use this option to clear all pending events.
Running the LCD/LED Availability Test function:
1.Press the Function key. Enter your password and press the Enter key to go to the Welcome Manager.
2.Press [6] and Enter.
The LCD changes all segments to black for 2 sec so that you can check for nonfunctioning LCD segments. All D6641 Line Cards turn the line LEDs on red for 2 sec and then green for 2 sec. The Power and System trouble LEDs turn on for 2 sec, then off. After the test completes, the system restores the LEDs to their previous state.
11.5 Busy Seconds (Line Busy) Reports
| The D6600/D6100IPv6 monitors and reports when a call group of receiver lines cannot receive | |
| signals. The receiver cannot process signals if its incoming telephone lines are in trouble, if | |
| other communicators have the line tied up, or if the line card is inoperative. The receiver | |
| interprets telephone lines that are not in trouble and taking calls as busy time. Telephone lines | |
| that are in trouble are not included in the busy time calculation. | |
| The amount of busy time accumulated during a 10 min period is the basis for a Busy Seconds | |
| Reports. The 10 min busy period begins when all lines in a call group become busy, or when a | |
| ||
| accumulated busy time and prints the Busy Seconds Report after the 10 min period ends. | |
| After at least 60 sec (10%) of busy time, the receiver generates a report. The D6600/ | |
| D6100IPv6 reports up to 100% busy time. | |
| Program the Busy Seconds Reports option to No if Busy Seconds Reports are not wanted for | |
| all lines. Setting the Line Sniff option to 2 disables reports for individual lines. | |
|
| |
i | Notice! | |
Enable Seconds Reports for UL Listed central stations. | ||
| ||
|
| |
| UL inspectors might investigate the amount of time the digital receiver lines cannot receive | |
| signals. Ensure that lines are available to process emergency signals on a timely basis. | |
| Excessive Line Busy Reports can indicate it is necessary to install additional lines in rotary | |
| with your primary receiver lines. | |
| Assign each line to a call group. For the group to start accumulating busy time, all lines in the | |
| call group must be online, in trouble, or without an operating line card. |
2012.11 08 4998122704 | Installation and Operation Guide | Bosch Security Systems, Inc. |
