Conettix Communications Receiver/ | Installation en 25 | |
Gateway | ||
| ||
|
|
8 | Installation | ||
|
|
| |
i | Notice! | ||
Refer to the appropriate Installation Supplement included with your product for the specifics | |||
| of your particular installation. | ||
|
|
| |
8.1 | Installation Check List | ||
|
| Check each receiver card to see that it is correctly positioned in the card guides at the | |
|
| ||
|
| ||
| top and bottom of the enclosure. Also confirm that connections did not loosen during | ||
| shipment (D6600 only). | ||
|
| Check each receiver card to see that it is correctly positioned in the card guides at the | |
|
| ||
|
| ||
| top and bottom of the enclosure. Also confirm that connections did not loosen during | ||
| shipment (D6600 only). | ||
|
| Ensure that the earth ground is connected and grounded through the AC inlet. | |
|
| ||
|
| ||
|
| If you are installing additional line cards, install the terminator cards now (D6600 only). | |
|
| ||
|
| ||
|
| After installing additional line terminator cards, install the line cards (refer to Card | |
|
| ||
|
| ||
| Installation, page 20). | ||
|
| Install the line terminator card(s) from your spares package(s). If there is a malfunction, | |
|
| ||
|
| ||
| you can quickly switch over to the replacement card (refer to Card Installation, page 20). | ||
|
| ||
i | Notice! | ||
You can install spare line terminator cards. Do not install spare line cards. | |||
| |||
|
|
| |
|
| Connect four or six conductor telephone cord(s) to the RJ11C jack(s) of the desired | |
|
| ||
|
| ||
| telephone line(s). Plug the other end of the modular telephone cord(s) into the telephone jack | ||
| on the appropriate line terminator card(s). | ||
|
| Connect the supplied AC transformer wiring leads to the AC terminals on the rear of the | |
|
| ||
|
| ||
| D6100IPv6. | ||
|
| Plug the AC cord (D6600 only) into a correctly wired 120 VAC, 60 Hz or 220 VAC, 50 Hz | |
|
| ||
|
| ||
| outlet (standard AC outlet). | ||
|
| ||
i | Notice! | ||
Maintain a 6.5 mm (0.25 in) gap, or greater, between power limited and | |||
| circuit wiring. | ||
|
|
| |
|
| Plug the AC transformer into the correctly wired wall receptacle that matches the voltage | |
|
| ||
|
| ||
| of the transformer. |
Bosch Security Systems, Inc. | Installation and Operation Guide | 2012.11 08 4998122704 |