Conettix Communications Receiver/ | D6600/D6100IPv6 Operation en 35 | |
Gateway | ||
| ||
|
|
11.2 | Normal Operation Mode | |
| In Normal Operation Mode, the D6600/D6100IPv6 sends messages immediately or in blocks to | |
| reporting devices (such as printers and computers) as soon as the devices are ready to | |
| receive the information. Signals do not remain visible in the display. If all reporting devices | |
| fail, the D6600/D6100IPv6 reverts to Manual Mode until a device returns to service. Normally, | |
| the D6600/D6100IPv6 sounds the Operator Alert Buzzer for new events received when the | |
| automation link fails. | |
| Typical Alarm Receiving Sequence | |
| 1. | An alarm occurs on Zone 3 at subscriber location 456. The user programs Account 456 to |
|
| report to Line 01 and does not assign Line 01 to report to a call group. |
| 2. | The OL LED glows green when the receiver answers the call and receives data. |
|
| The primary reporting device (such as an external printer or automation computer) |
|
| activates. If the external printer is a primary reporting device and Line 01 is not assigned |
|
| to Group Reporting, it prints. |
| 3. | If Line 01 is assigned to group 1 Reporting, the receiver’s external printer prints: |
| 4. | Line 01 hangs up. |
11.3 | Operating in Manual Mode | |
| If all reporting devices (such as printers and computers) fail, the D6600/D6100IPv6 reverts to | |
| Manual Mode until a device returns to service. | |
| D6600/D6100IPv6 | |
| The D6600/D6100IPv6 receives signals while in Manual Mode. The Operator Alert buzzer | |
| sounds. | |
| 1. | Press the Acknowledge button to shut off the operator alert buzzer. |
|
| Shuts off the operator alert buzzer |
|
| Compare the display to the printout to confirm you read the data correctly. |
|
| (For each alarm event, press the Acknowledge button twice; once to acknowledge the |
|
| alarm and once to print the event. As you step through this process, the event number |
|
| will diminish.) |
| 2. | Press the Acknowledge button to send the message to a connected printer. |
| 3. | Press the Acknowledge button. |
|
| Sends the message to a connected printer. |
| 4. | Press the Acknowledge button. |
| 5. | Press the Acknowledge button. |
|
| Sends the message to a connected printer. |
| 6. | Press the Acknowledge button. |
Bosch Security Systems, Inc. | Installation and Operation Guide | 2012.11 08 4998122704 |