Bosch Appliances D9412GV2 4.7Programming the Control Panel, 4.8Installing the Point Chart Label

D9412GV2/D7412GV2 Operation and Installation Guide 4.0 Installation

4.7Programming the Control Panel

If the control panel is not already programmed, review the D9412GV2/D7412GV2 Program Entry Guide

(P/N: F01U003636). Ensure that all accessory modules for desired features are available for installation. Place the reset pin in the locked position to copy or send information to and from the control panel.

Use the D5200 Programmer or the RPS to load a custom program into the control panel.

Move the reset pin to the normal position refer to

(Figure 4 on page 17). The control panel sends Reboot and Battery Reports to the receiver if programmed for reporting

4.8Installing the Point Chart Label

The point chart label is required for fire systems with verifications points.

A point chart label comes in the literature pack. Install the point chart label for fire or combined fire-and- burglary systems that use verification points.

Use the D9412GV2/D7412GV2 Program Record Sheet (P/N: F01U003635) to gather the necessary information for completing the point chart. Fill out the label and install it on the inside of the enclosure door (refer to Figure 2 on page 15).

Avoid smearing the entries on the chart. Use the peel-off backing to press the label in place.

4.9Testing the System

After installing and programming the control panel, test the system completely. Test the control panel and all devices for proper operation. Test after initially programming the control panel and after subsequent programming sessions.

Refer to the D9412GV2/D7412GV2/D7212GV2 Installation and Troubleshooting Quick Reference Guide (P/N: F01U003638) for complete Service Walk Test instructions.

Clear after Test: To clear the event memory and report buffer, momentarily close the reset pin. Events stored in the control panel’s event log are not cleared.

Bosch Security Systems, Inc. 5/05 F01U003641B 19