Bosch Appliances D9412GV2 12.5SDI Address, Access, Switch Settings, Serial Interface Modules SIMs

D9412GV2/D7412GV2 Operation and Installation Guide 12.0 SDI Devices

12.4.1 Access

Using Wiegand style cards or tokens, the D9210B can allow access for up to 996 cards or tokens on the D9412GV2, and up to 396 on the D7412GV2. User access authority can be configured to restrict access to certain doors or to certain periods of time. The reading of access cards, in addition to granting access, can control whether the system disarms. Used with the D9412GV2, the D9210B recognizes 249 master users by user name, passcode, and access authority. The D9210B recognizes 99 master users when used with the D7412GV2. Each master user supports three sub-users with unique cards or tokens having the same access level as the master user.

12.4.2 Switch Settings

Switches on the D9210B assign a unique address (1 to

8)to each module. Table 24 shows the correct switch setting for each D9210B address.

Table 24: Address Switch Settings for Access Control Module

Door Module		DIP Switch Settings
Addresses	1	2	3	41	52	62
1	ON	ON	ON		ON	ON
2	OFF	ON	ON		ON	ON
---------------D7412GV2 Maximum---------------
3	ON	OFF	ON		ON	ON
4	OFF	OFF	ON		ON	ON
5	ON	ON	OFF		ON	ON
6	OFF	ON	OFF		ON	ON
7	ON	OFF	OFF		ON	ON
8	OFF	OFF	OFF		ON	ON

1Switch 4, Fail Safe Mode:

ON = If SDI bus fails, relay energizes.

OFF = If SDI bus fails, relay de-energizes.

2Switches 5 and 6 must remain in the ON position.

12.5SDI Address 80

SDI Address 80, available on the D9412GV2 and D7412GV2 Control Panels, allows for two-way SDI to RS-232 information. This address is used with home or building automation software. A D9133 Serial Interface Module is required for this application.

12.5.1 Serial Interface Modules (SIMs)

The DX4010i RS-232 Serial Interface Module and the D9133 Serial Interface Module are four-wire powered SDI devices that provide connection for RS-232 devices to the D9412GV2 and D7412GV2 Control Panels. They use a specific communication protocol that is provided upon request. Contact Bosch Security Systems Technical Support Monday through Friday from 5 AM to 5 PM EST at 888-886-6189.

The DX4010i can be installed up to 305 m (1000 ft.) from the control panel, using 0.8 mm (22 AWG) wire. The DX4010i was not investigated by UL. Do not use DX4010i in UL Listed installations.

The D9133 can be installed up to 305 m (1000 ft.) from the control panel using 1.2 mm (18 AWG) wire. The D9133 was not investigated by UL. Do not use D9133 in UL Listed installations.

12.5.2 Address Settings

No jumper settings are required for the D9133 (SDI Address 80) for home or building automation purposes (Figure 26). Remove the jumper shunts for this purpose.

Figure 26: D9133 Jumper Setting for Address 80

1 2 3 4

80

The DX4010i has specific DIP switch settings for SDI Address 80 when home or building automation is desired. Figure 27 on page 59 shows the correct settings for Address 80.

58 Bosch Security Systems, Inc. 5/05 F01U003641B