Bosch Appliances manual D811 Module Wiring to the D9412GV2, 1 - D811 for Relay, On-boardpoints

D9412GV2/D7412GV2 Operation and Installation Guide 10.0 Off-Board Relays

10.2.2 Installation

Install the D811 in the enclosure with the control panel (Figure 22) or in an adjacent enclosure no more than

1.5m (5 ft.) from the control panel. Use 1.5 mm

(16 AWG) to 0.8 mm (22 AWG) wire.

To install D811 Modules in the enclosure with the control panel:

1.Align the D811 Module with any of the four mounting locations in the enclosure (Figure 2 on page 15).

2.Using the screws provided with the module, secure it in the enclosure.

Use the D137 Mounting Bracket or D9002 Mounting Skirt to install D811 Modules in enclosures with no available module mounting locations.

10.2.3 Wiring Connections

Power down the control panel to connect D811 Modules as shown in Figure 22 on this page and Figure 23 on page 52.

The D811 for Relay 53 connects to

Zonex 1.

The D811 for Relay 117 connects to

Zonex 2 on the D9412GV2.

Figure 22: D811 Module Wiring to the D9412GV2
		Reset Pin
	Disable All Except Battery
	Charging And Programming
	PERIPHERAL DEVICE CONNECTIONS
	RED	POWER +	32
	YELLOW	DATA BUS A	31		5
	GREEN	DATA BUS B	30
	BLACK	COMMON	29
	N.F.P.A.	ZONEX OUT 1	28	DATA
	Style 3.5
	Signaling			AUX	1
	Line		27
	Circuits	ZONEX IN 1		GND
		ZONEX OUT 2	26
		ZONEX IN 2	25
		ZONEX POWER +	24		5
		ZONEX COMMON	23
	Point 8	D5200/D5360
	S3 Option	PROG CONN
	Closed = 1KΩ EOL			DATA
	Normal Operation				2
	Open =AB-12 UL			AUX
	Bell Box 220 KΩ
21	22	GRN		GND
			3
1 - D811 for Relay 53			3-	On-board points
2- D811 for Relay 117

Bosch Security Systems, Inc. 5/05 F01U003641B 51