Bosch Appliances D9412GV2 13.0Programmer and Accessory Connections, 13.1Programmer Connector

D9412GV2/D7412GV2 Operation and Installation Guide 13.0 Programmer and Accessory Connections

13.0Programmer and Accessory Connections

13.1Programmer Connector

Refer to the D5200 Operation Manual

(P/N: 74-06176-000) for complete information on using the D5200 programmer.

To connect and disconnect the programmer:

1.Lock the Reset Pin (Figure 30).

2.Connect the D5200 Data/Power cord to the programming connector on the control panel (Figure 31).

3.Perform the desired programming function (send or receive program).

4.Disconnect the programmer.

Figure 30: Reset Pin

			1
	Reset Pin
Disable All Except Battery
Charging And Programming
PERIPHERAL DEVICE CONNECTIONS
RED	POWER +	32	2
YELLOW	DATA BUS A	31
GREEN	DATA BUS B	30
BLACK	COMMON	29

1 - Reset Pin locked (closed)

2 - Reset Pin normal (open) for normal control panel operation

13.2Programmer Access Reports

When a program is sent to the control panel, the control panel sends a Prog Access OK report 10 seconds after the handler exits or when the programmer disconnects. The prompt in routing must be programmed Yes to send this report.

13.3Accessory Connector

Use the accessory connector to connect the control panel to the D928 Dual Phone Line Switcher. The accessory connector is on the bottom right corner of the I/O board (Figure 31). The D928 lets the control panel use two telephone lines to send reports.

Refer to Section 7.11 D928 Dual Phone Line Switcher on page 29 for installation and operating instructions.

Figure 31: Programmer and Accessory
	Connections
		26
	NEX IN 2	25
	NEX POWER +	24
	ONEX COMMON	23
	D5200/D5360
	PROG CONN
	GRN
	1	2
1 -	Accessory connector
2 -	Programming connector

Bosch Security Systems, Inc. 5/05 F01U003641B 61