Bosch Appliances FW5.50 software manual 11.1Alarm Connections, 11.1.1Connect on alarm

Camera Browser Interface Alarm en 61

11 Alarm

11.1Alarm Connections

In the event of an alarm, the camera can automatically connect to a pre-defined IP address. The camera can contact up to ten IP addresses in the order listed until a connection is established.

11.1.1Connect on alarm

Select On so that the camera automatically connects to a pre- defined IP address in the event of an alarm. Select Follows input 1 so that the device maintains the connection for as long as an alarm exists.

11.1.2Number of destination IP address

Specify the numbers of the IP addresses to be contacted in the event of an alarm. The device contacts the remote locations one after the other in the numbered sequence until a connection is made.

11.1.3Destination IP address

For each number, enter the corresponding IP address for the desired remote station.

11.1.4Destination password

If the remote station is password protected, enter the password here.

Only ten passwords can be defined here. Define a general password if more than ten connections are required, for example, when connections are initiated by a controlling system such as the Bosch Video Client or the Bosch Video Management System. The camera connects to all remote stations protected by the same general password. To define a general password:

1.Select 10 in the Number of destination IP address list box.

2.Enter 0.0.0.0 in the Destination IP address field.

Bosch Security Systems Software manual AM18-Q0611 v5.50 2012.03