Bosch Appliances user manual VEZ-400 Mini PTZ Dome Installing a Surface Mount en

VEZ-400 Mini PTZ Dome Installing a Surface Mount en 21

screws enough to ensure that the camera base is secured to the ceiling.

11.Make the necessary Dip Switch settings (described in chapter 4.3). Note: This step can also be done later, but then the dome cover must be re-opened.

CAUTION!

When (re)mounting the dome cover to the camera base, make sure that each screw has a rubber O-ring, and that the large rubber O-ring is in place on the camera base. This ensures protection against water ingress.

12.Align the screw holes on the dome cover (item 6) with the camera base.

13.Attach the dome cover to the camera base using the four M4 x 12 Torx screws (with O-rings (item 4) attached) using the supplied Torx wrench. Make sure that the large rubber O-ring between the camera base and dome cover is in place to protect the camera against water ingress. Tighten the screws enough to ensure that the housing is secured to the camera base and that the rubber O-rings seal the dome cover against water ingress.

14.Remove the plastic film protecting the dome cover from scratches.

Bosch Security Systems, Inc. User Manual F.01U.252.635 2.0 2011.09