Bosch Appliances VG5 600 user manual Inside of Outdoor, Low Voltage flashing, On monitor display

58 en Troubleshooting GuideAutoDome 600 Series Analog PTZ Camera

Inside of Outdoor	– Check the status of the Heater Module (ON-66-ENTER).
Pendant bubble is	If status reports Heater No Power, then:
foggy	– Turn off the power to the AutoDome.
	– Check the FX103 fuse in the Power Supply Box for power (24 V) to the heater module.
	If O.K., then:
	– Check all wiring and connector pins to the heater module.
Low Voltage flashing	– If using a non-Bosch power supply, confirm that it meets the Bosch AutoDome power
on monitor display	ratings. See the AutoDome Datasheet for specifications.
	If O.K., then:
	– Check the mains input line voltage.
	If O.K., then:
	– Check that the maximum wire length from the power supply has not been exceeded.
	See the VG5 AutoDome Installation Manual.
	If O.K., then:
	– Measure the AC voltage input to the camera while power is applied to the camera. The
	voltage must be ≥ 21 VAC to stop the message.

F.01U.270.005 2.0 2012.06 User Manual Bosch Security Systems, Inc.