Brocade Communications Systems boot (HBA only)

Brocade Adapters Administrator’s Guide 159
53-1001256-01
boot (HBA only) B
boot (HBA only)
Updates the boot code in flash. The boot-over-SAN feature is not supported on the converged
network adapter (CNA).
The adapter id could be any one of the following:
•<adapter_id>
•<adapter_sn>
•<adapter_name>
•<adapter_hwpath>
NOTE
On Solaris systems, the Boot Code Image Upload menu is disabled if the host does not have a Fibre
Channel HBA card or if the driver version is 1.1.0.7 or lower.
Synopsis bcu boot --blunZone -c <cfg> -p <port_wwn> -r <rport_wwn> -l <lun_id | lun#>
bcu boot --upload [adapter_id] <image_file> [-a]
Description Boot commands enable you to query a boot configuration and set or disable the boot over SAN
configuration.
Operands --blunZone Creates the zonecreate command to be run on the switch.
-c cfg Specifies the boot LUN (BLUN) of the boot command.
-p port_wwn Specifies the world wide name of the port.
-r rport_wwn Specifies the world wide name of the rport.
lun_id Specifies the ID of the logical unit. The LUN ID is specified as a hexadecimal
byte; for example, FF.
lun# Specifies the number of the logical unit. The LUN number is specified as a
hexadecimal, eight-byte string; for example, 09AABBCCDDEEFF00.
--upload Updates the boot code in flash.
adapter_id Specifies the ID of the adapter on which boot code is updated.
image_file Specifies the name of the boot code image file.
-a Indicates the boot code is uploaded to all the Brocade adapters found on the
host. The adapter_id is not specified if -a is specified.
Example bcu boot --blunZone -c BLUN -p 10:00:00:05:1e:41:9a:cb -r 50:00:00:05:1e:41:9a:ca
-l 09AABBCCDDEEFF00
See Also “bios”