Message

Meaning and Action

 

 

Push in

None of the trays are properly inserted.

the Tray

Action:

 

Push the all paper trays completely back into the printer.

Empty

The face down tray is full.

Exit Tray

Action:

 

Remove the paper from the face down tray.

Replace Black

The black toner cartridge is empty.

Toner (K)

Action:

 

Replace the black toner cartridge.

 

See 8.1.2 “Replacing the Toner Cartridges”

 

 

Reinsert Black

There is no black toner cartridge inserted in the printer or the

Toner (K)

cartridge is improperly set.

 

Action:

 

Grip the levers at each end of the black toner cartridge with your

 

fingers, then push down firmly to rotate the levers forward to

 

install the cartridge.

 

See 8.1.2 “Replacing the Toner Cartridges”

Operation Error

The request from the computer could not be printed.

Please Press Set

Action:

 

Press the <Form Feed/Set> button and cancel printing. Check

 

the printer driver settings and reprint.

Operation Denied

An illegal operation was performed on the control panel during

While Printing

printing.

 

Wait until printing finishes.

 

 

ServCallJ1

This is a warning message. Contact your dealer or Brother

 

authorized service representative.

Close

The front cover is open.

Front Cover

Action:

 

Make sure that the front cover is properly closed.

Replace Magenta

The magenta toner cartridge is empty.

Toner (M)

Action:

 

Replace the magenta toner cartridge.

 

See 8.1.2 “Replacing the Toner Cartridges”

 

 

Reinsert Magenta

There is no magenta toner cartridge inserted in the printer or the

Toner (M)

cartridge is improperly set.

 

See 8.1.2 “Replacing the Toner Cartridges”

Out of Memory

There is not enough memory available for the printer to function

Please Press Set

normally.

 

Action:

 

Press the <Form Feed/Set> button and cancel printing. Install a

 

memory expansion card and reprint.

 

See Appendix A.5 “Adding the Expansion Memory”.

 

If you are unable to install a memory expansion card, print after

 

configuring the printer driver as follows:

 

• Turn off the Duplex Printing and Multiple Page setting.

 

• Change the setting in ‘Document Types’ to ‘Normal’ in the

 

“Graphics” tab (Windows), or the “General” dialog box

 

(Macintosh). Note that this lowers image quality.

 

See “Help”

6-21