Before starting installation

Be careful when handling the NC-9100h. There are many delicate electronic components that are susceptible to damage from static electricity. To avoid such damage, use the following precautions when handling the board.

■Leave the NC-9100h in its anti-static bag until you are ready to install it.

■Make sure that you are adequately grounded before touching the NC-9100h. Use an anti-static wrist strap and a grounding mat if possible. If you do not have an anti-static wrist strap, touch the bare metal surface on the back of the machine before handling the NC-9100h.

■Avoid moving around the work area in order to eliminate static charge build-up.

■If possible, do not work on a carpeted area.

■Do not flex the board and do not touch the components on the card.

Tools Required:

Phillips Screwdriver

Step 1: Hardware installation

WARNING

DO NOT touch the surface of the main boards within 15 minutes after turning off the power.

1 Turn the DCP power switch off, unplug the DCP power cord from the AC outlet, and then disconnect the interface cable.

OPTIONAL ACCESSORIES 15 - 6