Brother NV1200 146, Turn the screwdriver toward the back, Set the embroidery foot perpendicular

EMBROIDERY —————————————————————————————————————————————

eLoosen the presser foot holder screw and remove the presser foot holder.

Turn the screwdriver toward the back.

ab

c

aScrewdriver

bPresser foot holder

cPresser foot holder screw

fHold the embroidery foot with your right hand, as shown.

Hold the embroidery foot with your index finger wrapped around the lever at the back of the foot.

a

aLever

gWhile pressing in the lever with your finger, fit the embroidery foot bar over the needle clamp screw to attach the embroidery foot to the presser foot bar.

1

2

hSecure the embroidery foot with the presser foot holder screw.

Set the embroidery foot perpendicular.

iFirmly tighten the presser foot holder screw. Turn the screwdriver toward the front.

CAUTION

●Do not hit the needle with your finger or the embroidery foot “Q” when attaching it. The needle may break or cause injury.

●Be sure to tighten the screw with the included screwdriver. If the screw is loose, the needle may hit the presser foot and break or bend.

●Before sewing, always turn the handwheel toward you (counterclockwise) slowly to make sure that the needle does not hit the presser foot. Otherwise, the needle may break or bend.

aEmbroidery foot bar

bNeedle clamp screw

146