Brother NV1200 operation manual 188

APPENDIX ——————————————————————————————————————————————

Error Message	Probable Cause
	A stitch other than the buttonhole, bar tack or darning stitch was
	selected and the start/stop button was pressed while the buttonhole
	lever is lowered.
	The buttonhole, bar tack or darning stitch was selected and the start/
	stop button was pressed while the buttonhole lever is raised.
	The start/stop button, reverse/reinforcement stitch button or thread
	cutter button was pressed while the presser foot was raised.
	You tried to combine more than 70 decorative stitches, satin stitches,
	cross stitches or combined utility stitches.
	The memory is full and the stitch or pattern cannot be saved.
	You pressed the back key or the utility stitch key or the embroidery key
	while a pattern was selected.
	You changed the stitch pattern settings, and then tried to save them by
	pressing the manual memory key.
	You tried to select an embroidery pattern or change the layout when
	the needle was down.
	The machine is turned on while the needle is lowered and the
	embroidery unit is attached.
	This message is displayed when the embroidery unit is trying to
	initialize while the embroidery foot is lowered.
	When 13 or more patterns are in “Removable Disk”, a pattern was
	being retrieved.
	Retrieving the pattern
	The reverse/reinforcement stitch button, needle position button or
	thread cutter button was pressed while the bobbin winder shaft is
	moved to the right.
	A pattern is being stored.
	The start/stop button or reverse/reinforcement stitch button was pressed
	when no pattern is selected.
	Bobbin thread has run out.
	Little bobbin thread remains.

188