Brother NV1200 AThreadguide. the machine to the needle bar thread, BLower the presser foot lever

————————————————————————————————————————————————————

Note

zIf the needle was not completely threaded, but a loop in the thread was formed in the eye of the needle, carefully pull the loop through the eye of the needle to pull out the end of the thread.

CAUTION

●When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend.

eRaise the presser foot lever, pass the end of the thread through the presser foot, and then pull out about 5 cm of thread toward the rear of the machine.

1

a5 cm

XThe upper threading is finished.

Now that the upper threading and the lower threading are finished, you are ready to begin sewing.

Note

zIf the needle is not raised, the needle threader cannot thread the needle. Be sure

to press (Needle position button) to raise the needle before using the needle threader.

Threading the needle manually (without using the needle threader)

When using special thread, thread with a thickness of

130/20 or thicker, the wing needle or the twin needle 1 which cannot be used with the needle threader,

thread the needle as described below.

aThreadguide. the machine to the needle bar thread

•For details, refer to “Upper Threading” (page 29).

bLower the presser foot lever.

1

aPressor foot lever

cPass the thread through the eye of the needle from front to back.

dRaise the presser foot lever, pass the end of the thread through the presser foot, and then pull out about 5 cm of thread toward the rear of the machine.

Upper Threading 33