Brother NV1200 operation manual DOpen the top cover, Needle position button

GETTING READY ————————————————————————————————————————————

cPress (Needle position button) once or twice to raise the needle.

1

aNeedle position button

XThe needle is correctly raised when the mark on the handwheel is at the top, as shown below. Check the handwheel and, if this mark is not at

this position, press (Needle position button) until it is.

1

aMark on handwheel

dOpen the top cover.

eRemovespool pin.the spool cap that is inserted onto the

1

2

aSpool pin

bSpool cap

fPlace the spool of thread onto the spool pin. Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom.

CAUTION

●If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin or the needle may break.

gSlide the spool cap onto the spool pin. Slide the spool cap as far as possible to the right, as shown, with the rounded side on the left.

hWhile holding the thread lightly with your right hand, pull the thread with your left hand, and then pass the thread behind the thread guide cover and to the front.

1

aThread guide cover

30