Brother NV1200 operation manual Eyelet Stitching, Eyelet stitch, Attach monogramming foot N

————————————————————————————————————————————————————

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/64 and 3/16 inch).

			Stitch Width		Stitch Length		Presser
Stitch Name	Pattern	Application	[mm (inch)]		[mm (inch)]
							Foot
			Auto	Manual	Auto	Manual
	62			7.0, 6.0 or		7.0, 6.0 or
Eyelet stitch		Sewing eyelets, for example, on	7.0	5.0	7.0	5.0	N
		belts	(1/4)	(1/4, 15/64	(1/4)	(1/4, 15/64
				or 3/16)		or 3/16)

aAttach monogramming foot “N”.

•For details, refer to “Replacing the presser foot” (page 42).

bSelect stitch 62 .

•For details, refer to “Selecting stitching” (page 49).

cAdjust either the stitch width or the stitch length to select the desired eyelet size.

1 2 3

a7mm

b6mm

c5mm

•For details, refer to “Adjusting the stitch width” (page 56) and “Adjusting the stitch length” (page 57).

Lower the needle into the fabric at the
dbeginning of the stitching, and then lower the	3
presser foot lever.

eStart sewing.

XOnce sewing is completed, the machine automatically sews reinforcement stitches, then stops.

fUse the eyelet punch to cut a hole in the center of the eyelet.

•When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.

Memo

zIf thin thread is used, the stitching may be too open. If this occurs, sew the eyelet twice before removing the fabric, one on top of the other.

Eyelet Stitching 115