CONOSCERE LACONOZCA SUKNOWING YOUR MACCHINAM ÁQUINASEWING
DA CUCIREDE COSERMACHINE
33
1
4 2
5 3
1
Upper Threading
1.Raise the presser foot using the Presser Foot Lever.
2.Raise the needle to its highest position by turning the balance wheel toward you (counterclockwise).
1 Presser foot lever
3.Place a spool of thread on the horizontal spool pin and press a spool cap onto the spool pin to hold the thread spool firmly in place.
The thread end should come from the bottom front of the spool.
CAUTION
•If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break.
•Use the spool cap (large, medium or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool and cause the needle to break.
CAUTION
Be sure to thread the machine properly. Improper threading can cause the thread to tangle and break the needle, leading to injury.
4.Deliver the upper thread as shown in this diagram.
5.Make sure to guide the thread through the thread
2Thread
6.Place thread behind the guide above the needle.
7.Thread the needle from front to back leaving a thread tail of about 5 cm (2").
NOTE:
If the thread
Incorrectly feeding the thread may cause sewing problems.
