CONOSCERE LACONOZCA SUKNOWING YOUR MACCHINAM ÁQUINASEWING
DA CUCIREDE COSERMACHINE
12
1
2
2 
1
Lower Threading
CAUTION
Setting the bobbin improperly may cause the thread ten- sion to loosen, breaking the needle and resulting in injury.
1Wound evenly
2 Wound poorly
CAUTION
Be sure to turn off the power. If you accidentally step on the foot controller and the machine begins to operate, injury could result.
1.Raise the needle to its highest position by turning the balance wheel toward you (counterclockwise) and raise the presser foot lever.
2.Slide the button and open the cover.
1Slide button
2 Cover
3. Insert the bobbin so the thread comes out in the direction shown by the arrow.
* Use bobbins intended for use with this machine.
CAUTION
Be sure the bobbin is set so the thread unrolls in the correct direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or the needle to break.
Hold the thread end, push the bobbin down with your finger, and pass the thread securely through the thread cutting groove.
4.Replace the bobbin cover. Place the left tab in place (see arrow 1 at left), then press lightly on the right side (see arrow 2 at left)
until the cover clicks into place.
*Insert the cover so that the end of the thread comes out from the back of the cover (as shown by the slanted line in the illustration at the left).
31
