Cabletron Systems ELS10-26 manual Addresses Configuration Group

ELS10-26 MIB

6.1.5 Addresses Configuration Group

The Addresses Configuration Group consists of the parameters described below.

lxaddrStatics	{lxaddr 1}
Counter Read-Only

The number of static addresses which are currently stored in the ELS10-26.

lxaddrDynamics	{lxaddr 2}
Counter Read-Only

The number of learned addresses in the ELS10-26’s address table.

lxaddrDynamicMax	{lxaddr 3}
Gauge Read-Write

The maximum number of spanning tree addresses which have been learned since the ELS10-26 was last booted (or this parameter was last reset by the NMS).

lxaddrDynamicOverflows	{lxaddr 4}
Counter Read-Write

The number times an address was not learned due to insufficient address table space.

lxaddrFlags	{lxaddr 5}
Integer Read-Write

Flags to describe the use and control of this address entry. Each bit has a different meaning. The NMS must always set either entry-static or entry-none; however, for GetRequests, the NMS will see either no bits set (if the entry does not exist), or exactly one of the following bits set:

•bit 29 is reserved.

•entry-static = 28, if set then this is a pre-defined customer address, e.g., an IEEE Spanning Tree static address.

6-13