Cabletron Systems manual ELS10-26 MIB

ELS10-26 MIB

lxadminStaticPreference	{lxadmin 16}
Integer Read-Write 2

The value to assign to ipRouteMetric2, when adding a statically-defined entry to the IP Routing Table.

lxadminRipPreference	{lxadmin 17}
Integer Read-Write

The value to assign to ipRouteMetric2, when adding a RIP-learned entry to the IP Routing Table.

lxadminRipRouteDiscards	{lxadmin 18}
Counter Read-Only

The number of times a route learned via RIP was not added to the IP Routing Table due to insufficient Routing Table space.

lxadminRebootConfig	{lxadmin 19}
Integer Read-Write

The configuration file that will be used when the ELS10-26 reboots. This parameter is normally set by the ELS10-26 automatically; however, an NMS may explicitly set it to either no-change (1) or revert-to-defaults (3). The possible values include:

•no-change (1) – the ELS10-26 will not change its configuration parameters when it reboots.

•tftp-config (2) – the ELS10-26 will use a file that was sent via TFTP when it reboots .

•revert-to-defaults (3) – the ELS10-26 will revert to its factory specified defaults when it reboots .

Setting this parameter to a value of 2 will result in an error condition.

2.If a value for ipRouteMetric2 is explicitly provided when an entry is created, then lxadminStaticPreference will be ignored.

6-9