Sun Microsystems 3900 Series, 6900 Series manual Appendix B SUNWsecfg Error Messages

TABLE B-1Virtualization Engine SUNWsecfg Error Messages (Continued)

Message	Description and Cause of Error		Suggested Action
Common to	1.	Device-side operating mode is not	Log in to the virtualization engine and
virtualization engine		set properly.	verify that the device, host, and
	2.	Device-side UID reporting scheme	network settings are correct. Make sure
		is not set properly.	the virtualization engine hardware is
	3.	Host-side operating mode is not set	not in ERROR 50 mode. If required,
		properly.	power cycle the virtualization engine
	4.	Host-side LUN mapping mode is	hardware, or disable the host-side
		not set properly.	switch port. Run the setupve -n
	5.	Host-side Command Queue Depth	ve_name command and enable the
		is not set properly.	switch port.
	6.	Host-side UID distinguish is not set
		properly.
	7.	IP is not set properly.
	8.	Subnet mask is not set properly.
	9.	Default gateway is not set properly.
	10. Server port number is not set
		properly.
	11. Host WWN Authentications are not
		set properly.
	12. Host IP Authentications are not set
		properly.
	13. Other VEHOST IP is not set
		properly.
checkslicd	Cannot establish communication with		Run startslicd -n ${vepair}.
	${vepair}.
checkslicd	Cannot establish communication with		Determine the host name associated
	virtualization engine pair ${vepair}		with ${initiator} by using the
	initiator {$initiator}.		showvemap -n ${vepair} -f
			command output. Run the command
			resetve -n vename.
checkvemap	Cannot establish communication with		Run the command again. If this fails,
	${vepair}		check the status of both virtualization
			engines. If there is an error condition,
			see Appendix A for corrective action.

Appendix B SUNWsecfg Error Messages 133