Sun Microsystems 3900 Series manual Controller State Red Info/Action Recommended action Change

Category	Component	EventType	Sev	Action	Description	Information
t3	controller	State	Red	Y	[ Info/Action ]	Recommended action:
		Change-
					controller.u1ctr	1.	Telnet to affected
					in T3 diag213		Sun StorEdge T3+
					(ip=xxx.20.67.213)		array.
					is now Not-Available	2.	Verify the
					(status-state changed		controller state
					from unknown to		with ‘fru stat’ and
					ready-disabled)		‘sys stat’.
						3.	Run ‘logger -
					Information: The Sun		dmprstlog’ to
					StorEdge T3+ array		capture controller
					controller has been		information.
					disabled.	4.	Re-enable the
							controller if
							possible (enable u)
						5.	Replace the
							controller, if
							necessary.
t3	disk	StateChange-	Red	Y	[ Info/Action ]	Information: The Sun
						StorEdge T3+ array
					disk.u1d5 in T3	has reported that a
					rasd3-t3b1	disk has failed.
					(ip=xxx.0.0.41) is
					now Not-Available	Recommended action:
					(status-state changed
					from unknown to	1.	Telnet to the
					fault-disabled).		affected Sun
							StorEdge T3+ array
						2.	Verify that the disk
							state is in fru
							stat, fru list,
							and vol stat.
						3.	Replace the disk, if
							necessary.

Chapter 8 Troubleshooting the Sun StorEdge T3+ Array Devices 119

For Internal Use Only