To Quiesce the I/O on the A3/B3 Link

1.Determine the path you want to disable.

2.Disable the path by typing the following:

#vxdmpadm disable ctlr=<c#>

3.Verify that the path is disabled:

#vxdmpadm listctlr all

Steps 1 and 2 halt I/O only up to the A3/B3 link. I/O will continue to move over the T1 & T2 paths, as well as the A4/B4 links to the Sun StorEdge T3+ array.

To Suspend the I/O on the A3/B3 Link

Use one of the following methods to suspend I/O while the failover occurs:

1.Stop all customer applications that are accessing the Sun StorEdge T3+ array.

2.Manually pull the link from the Sun StorEdge T3+ array to the switch and wait for a Sun StorEdge T3+ array LUN failover.

a.After the failover occurs, replace the cable and proceed with testing and FRU isolation.

b.After testing is complete and any FRU replacement is finished, return the controller state back to the default by using the virtualization engine failback command.

Caution This action will cause SCSI errors on the data host and a brief suspension of I/O while the failover occurs.

Chapter 2 General Troubleshooting Procedures 13

For Internal Use Only

Page 29
Image 29
Sun Microsystems 3900 Series, 6900 Series manual To Quiesce the I/O on the A3/B3 Link, To Suspend the I/O on the A3/B3 Link