3

Printer Settings Menu

NOTE

•This function is only available if 'Booklet' is set to [On].

•Pressing [ ] increase the setting value by 0.001" (0.05 mm) each time the key is pressed. Pressing [ ] decreases the setting value by 0.001" (0.05 mm) each time. Holding down either [ ] or [ ] continuously speeds up the value alteration.

•If this setting is used in combination with the 'Offset Short Edge/Offset Long Edge' or 'Margin', the values of these three settings are added together.

Transparency Interleaving

Off*, Blank, and Printed

If you are printing on transparencies, you can use this setting to output a sheet of paper after each transparency. The paper can be blank, or it can be a paper copy of the transparency.

If [Off] is selected, no sheets are interleaved with the transparencies.

If [Blank] is selected, a blank sheet of paper is inserted between each transparency.

If [Printed] is selected, a printed paper from the print job is inserted between each transparency.

When [Blank] or [Printed] is selected, you can set Transparency Interleaving to print multiple copies in the number specified in [Copies] settings.

IMPORTANT

[Collate] is the only 'Finishing' setting that you can specify to use in combination with 'Transparency Interleaving'.

NOTE

If [Printed] is selected, the paper printouts are included in the Prints count. However, if [Blank] is selected, they are not included in the Prints count.

Transparency Printing

Transmissive*, Reflective

Transparencies are printed according to the method suited to the type of the selected OHP (Over Head Projector) device.

NOTE

•This setting does not affect the printing of sheets of paper for insertion between transparencies.

•When printing on OHP film, the setting for 'Toner Save' is invalid. However, it does not affect the printout of sheets of paper for insertion between transparencies.

3-38Settings Menu