3

Printer Settings Menu

■Margin

-1.90 to +1.90 inches (in increments of 0.01 inches); 0.00* inches

This setting enables you to set the page margin. The settings can be set in increments of 0.01" (0.5 mm) from -1.90" (-50.0 mm) through +1.90" (+50.0 mm).

Use [ ] to increase the width of the inside margin.

Use [ ] to increase the width of the outside margin.

 

[0 inches]

[ + ]

[ - ]

 

 

Center

 

 

 

Center

 

 

Center

 

 

 

 

 

 

 

 

 

 

 

 

Margin Left

 

Margin Right

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

You can specify the edge along which the margin will be created in the 'Binding Location' setting (previous setting). To create a margin along one of the edges of the paper, use this setting in combination with the 'Binding Location' setting.

IMPORTANT

If this setting moves the image outside the printable area, part of the image may be cut off.

NOTE

•If this setting is used in combination with 'Offset Short Edge/Offset Long Edge', the values of the two settings are added together.

• Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is pressed. Pressing [ ] decreases the value by 0.01" (0.5 mm) each time. Holding down either [ ] or [ ] continuously speeds up the value alteration.

3-22Settings Menu