3
Printer Settings Menu
■Offset Short Edge/Offset Long Edge (Front)
This setting enables you to set the offset position. The settings can be set in increments of 0.01" (0.5 mm) from
The print position on the front page is adjusted in the vertical or horizontal direction to the value specified in the setting value.
To adjust the print position on the back page, set 'Offset Short Edge/Offset Long Edge (Back)' (the next setting).
You can increase or decrease the setting in increments of 0.01" (0.5 mm) to adjust the print position, as described below.
Offset Short Edge (Front): Increasing the setting value moves the image in the rightward X direction on the paper. Decreasing the setting value moves the image in the leftward X direction on the paper.
Offset Long Edge (Front): Increasing the setting value moves the image in the downward Y direction on the paper. Decreasing the setting value moves the image in the upward Y direction on the paper.
Area adjusted using
X[+]
ABC | using |
| Y | Part of the |
| original margin | |||
|
| |||
adjusted | Adjustment |
| ABC | |
Adjust using | [+] | |||
| ||||
| Area | Y |
|
|
|
| - |
|
|
Front |
|
|
| Front |
IMPORTANT
Please note that if the print position is adjusted to place print data outside the printable area, the portion outside the printable area is not printed.
NOTE
•If this setting is used in combination with 'Margin', the values of the two settings are added together.
• Pressing [ 
] increases the setting value by 0.01" (0.5 mm) each time the key is pressed. Pressing [ 
] decreases the value by 0.01" (0.5 mm) each time. Holding down either [ 
] or [ 
] continuously speeds up the value alteration.