ii
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Canadian Compliance Statement
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matérial brouilleur du
Canada
EMC (Electromagnetic Compatibility)
Documents:
89/336/EEC—European Council Directive on the Approximation of the Laws of the Member states Relating
to Electromagnetic Compatibility (EMC Directive).
Testi ng:
Emissions: EN 55022
Immunity: EN 50082-1
Emissions
Documents:
1 CISPR Publication 22/EN 55024—Limits and Methods of Measurement of Ra dio Interference
Characteristics of Information Technology Equipment (ITE).
2 Federal Communications Commission (FCC)
a) 47 Code of CFR, chapter I
i)Part 2—Frequency Alloc. And radio Treaty Matters; Gen. Rules and Reg.
(1)Subpart J - Eq. Auth. Procedures
ii)part 15—Radio Frequency Devices
(1)Subpart B - Unintentional Radiators
3 ANS I C63.4—Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and
Electronic Eq in the Range of 9 kHz to 40 GHz
4 ICES-003—Interference - Causing Eq Standard - Digital Apparatus
5 AS/NZS 3548—Limits and Methods of Measurement of Radio Disturbance Ch arac. of Info. Tech. Eq.
6 VCCI—Volunt. Control council for Interference by Info. Tech. Eq.
Test setup shall conform to ANSI C63.4
Testing to be performed to CISPR 22/EN55022 Class-A and FCC Class-A limits
The quasi-peak detection mode is to be used for measurements from 30 MHz to 1 GHz and the an tenna should
be placed at a distance of 10 meters from the Equipment Under Test (EUT). To comply with the FCC Rules
and Regulations, testing must be performed to 5.3125 GHz (the 5th harmonic of t he 1.0625 GHz clock) at a
test distance of 3 meters using the average detection mode.
Immunity
1 EN 50082-1: 1998—Electromagnetic Compatibility - Generic Immunity Standard - Part 1: Residential,
Commercial and Light Industry
2 EN 61000-4-2—Electromagnetic Compatibility (EMC) - Part 4: Testing and Measurement Techniques -
Section 2; Electrostatic Discharge Immunity Test
3 EN 61000-4-3—Electromagnetic Compatibility (EMC) - Part 4: Testing and Measurement Techniques -
Section 3: Radiated, Radio Frequency, Electromagnetic field Immunity Test