Chapter 4 Installing the Internet Streamer CDS Software and Initially Configuring a CDE
Running the BIOS Setup Utility
Note For the CDE100, use the internal
For the CDE200, do not use the internal
You also need to configure the ports on the CDE200 as shown below:
•The two
Ethernet Management | Gigabit Ethernet |
Ports | Management Ports |
|
|
eth0 | g1/0 |
|
|
eth1 | g2/0 |
|
|
•The four interface ports on the stream interfaces are GigabitEthernet 3/0, GigabitEthernet 4/0, GigabitEthernet 5/0 and GigabitEthernet 6/0 using channel bonding 2 (see Figure
Ethernet Stream | Gigabit Ethernet Stream |
Interface Ports | Interface Ports |
|
|
eth2 | g3/0 |
|
|
eth3 | g4/0 |
|
|
eth4 | g5/0 |
|
|
eth5 | g6/0 |
|
|
Installation and Configuration Order
Perform the initial installation and configuration of your CDS network in the following order:
1.Run the BIOS setup utility on each CDE in the CDS network.
2.Install the CDS Release
3.Configure the CDSM.
Caution It is very important that the onboard SCSI controller be disabled on the CDE200. Do this by physically opening the CDE200 case (by removing two side screws and a back thumbscrew), and verifying that the jumper labeled
Running the BIOS Setup Utility
Running the BIOS setup utility is different for the CDE100 and the CDE200; therefore, this section provides a separate BIOS setup procedure for each CDE.
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
|
| |
|
