Cisco Systems 124778, 124792, 159330 manual Installation Warning, Operating Temperature Warnings

Chapter 1 Introduction

1.2.1 Installation Warning

Figure 1-8 ESD Wrist Strap Connection Point

124769

ESD Connection

Point

•Keep the system area clear and dust-free during and after the installation.

•Always check for possible hazards before beginning work.

•This equipment is designed to permit the connection of a grounded conductor for the DC supply circuit at the equipment.

1.2.1Installation Warning

The following safety guidelines should be observed when transporting or moving the system to the install location:

•Before moving the Cisco AC/DC Power System, read the system specifications sheet to determine if the site meets all the size, environmental, and power requirements.

•The Cisco AC/DC Power System should be properly mounted to the equipment rack.

The Cisco AC/DC Power System is designed for installation in restricted access locations. A restricted access location is defined as an equipment location where both of the following conditions apply:

•Access can only be gained by service persons or users who understand the restrictions applied to the location and any precautions that must be taken.

•Access to the system is obtained through the use of a tool or lock and key, or other means of security, and is controlled by the authority responsible for the location.

1.2.2Operating Temperature Warnings

Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of: 55° Celsius.

Statement 1047

Cisco AC/DC Power System User Guide, R1.0

May 2006 1-9